Publicidad
Idiomas disponibles
Idiomas disponibles
QUICK PROGRAMMING GUIDE 912-UC DVB-S/S2
Start/on
Main menu
Select series
Transcodifi cador 912 QPSK - COFDM
NIT Table
Select series
912-UC IF processor DVB-S/S2
912-MS Modulators
912-UC IF processor DVB-S/S2
Confi gure module
Set the programming switch of the 912-UC module to the ON position. The programming
Inputs
1 input
Processor 1
Processor 1
On
Power LNB
Off
Sat band
Low
Sat polarity
Vertical (13V)
Input frequency
950
Symbol rate
27500
Roll off
0.35
Bandwidth
Auto
Output frequency
950
Attenuation
6
Processor 2
Set the programming switch of the 912-UC module to the OFF position. The programming
indicator will now light up and remain lit.
OK++OK+T
OK++OK+T
OK++OK+T
OK++OK+T
OK++OK+T
MHz
MHz
OK++OK+T
KBd
6
MHz
OK++OK+T
MHz
dB
OK++OK+T
indicator light will now go out.
Press the Power On key of the PS-011 to start up the
system.
OK
Choose Select Series to select the programming series.
Select the series: 912-UC IF processor DVB-S/S2.
OK
To commence programming the module, select Confi gure
OK
module.
Select the number of inputs: 1 to confi gure as a closed
loop and 2 to confi gure separately. In both cases
processors 1 and 2 are available.
Select on/off in processor 1 to activate it.
Select LNB Power supply on/off. Then press T to transmit.
Select the satellite band (High/Low), the polarisation
(Vertical/Horizontal). Then press T to transmit.
Use the numeric keypad to enter the IF frequency of the
Keypad + T
input transponder. Then press T to transmit.
Enter the symbol rate of the transponder using the
Keypad + T
numeric keypad. Then press T to transmit.
Select the roll off. Then press T to transmit.
Select the bandwidth of the output transponder. You can
Keypad + T
do this using either the numeric keypad or the pull-down
or
menu. You can also select Auto. Then press T to transmit.
Use the numeric keypad to enter the IF frequency of the
Keypad + T
output transponder. Then press T to transmit.
Keypad + T
Enter the attenuation at the output of the module
or
using the numeric keypad. Then press T to transmit.
Same as processor 1.
ENG
Publicidad
