MAC TOOLS MCF601 Manual De Instrucciones página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fig. D
Variable Speed Trigger and Forward/
Reverse Control Button (Fig. A)
The tool is turned on and off by pulling and releasing
the variable speed trigger
3
. The farther the trigger is
depressed, the higher the speed of the tool. Your tool is
equipped with a brake. The chuck will stop as soon as the
trigger switch is fully released.
A forward/reverse control button
rotational direction of the tool and also serves as a
lock-off button.
To select forward rotation, release the trigger and
depress the forward/reverse control button on the right
side of the tool.
To select reverse, depress the forward/reverse control
button on the left side of the tool.
nOTE: The center position of the control button locks the
tool in the off position. When changing the position of the
control button, be sure the trigger is released.
nOTE: Continuous use in variable speed range is not
recommended. It may damage the switch and should
be avoided.
nOTE: The first time the tool is run after changing the
direction of rotation, you may hear a click on start up. This is
normal and does not indicate a problem.
Worklights (Fig. E)

CAUTION: Do not stare into worklights. Serious
eye injury could result.
There are three worklights
8
collar
. The worklights will be activated when the trigger
7
switch is squeezed.
The beam will automatically turn off 20 seconds after the
trigger switch is released.
nOTE: The worklights are for lighting the immediate work
surface and are not intended to be used as a flashlight.
12
4
determines the
located around the chuck
Fig. E
8
7
Performing an Application (Fig. A)

WARNING: To reduce the risk of personal
injury, ALWAYS ensure workpiece is anchored or
clamped firmly.

WARNING: Always wait until the motor has come to
a complete standstill before changing the direction
of rotation.
Prior to Performing Work
Install the appropriate bit or accessory into the chuck. Refer
to Quick-Release Chuck.

WARNING:
Do not use this tool to mix or pump easily
combustible or explosive fluids (benzine,
alcohol, etc.).
Do not mix or stir flammable liquids
labeled accordingly.
Screwdriving
Your tool has a clutch with adjustable torque for driving
and removing a wide array of fastener shapes and sizes. The
numbers 1–15 on the mode selection collar 
set a torque range for screwdriving. The higher the number
on the collar, the higher the torque and the larger the
fastener which can be driven.
1. Turn the mode selection collar 
desired position. Refer to Mode Selection.
2. Pull the trigger switch applying pressure in a straight
line with the bit until the fastener is seated at the
desired depth in the workpiece.
Recommendations for screwdriving
Start with lower torque settings, then advance to higher
torque settings to avoid damage to the workpiece
or fastener.
Make some practice runs in scrap or on unseen areas of
the workpiece to determine the proper position of the
mode selection collar.
Drilling
iMPORTAnT: For MASONRY, such as brick, cement, cinder
block, etc., use carbide-tipped masonry bits.
1. Turn the mode selection collar
Refer to Mode Selection.
English
are used to
 5 
 5 
to the
5
to the MAX symbol.
9

Publicidad

Tabla de contenido
loading

Tabla de contenido