Char-Broil 2897588 Guía Del Producto página 4

ASSEMBLY OF ROD BRACKET
1. Insert one #10-24x5/8" flat head screw (A)
into one roller bering as shown.
2. Insert the end of the flat head screw through
the rod bracket.
3. Install and tighten one #10-24 acorn nut (B).
Tighten securely with a phillips screwdriver.
INSTALL BRACKETS
1. Insert the rod bracket into the mating holes as
the side of the grill, as shown at right.
2. Insert the Motor Bracket into the mating holes
on the opposite side.
3. Note that you may install the brackets on either
side of grill, depending on how your Outdoor
Kitchen is configured.
4. Install the rod bracket with the roller bearing
facing away from the grill.
INSTALL YOUR MOTOR
1. Install the Motor onto the motor bracket by
aligning the mounting tabs with the bracket
slots.
2. Allow the motor to come to a rest at the bottom
of the slots.
ROLLER BEARINGS
A
4
B