Important Safety Information - Hartke Kickback KB12 Manual Del Usario

Important Safety Information

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK)
AS THERE ARE NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
This lightning flash with arrowhead symbol within an equilateral triangle
is intended to alert the user to the presence of non-insulated "dangerous
voltage" within the product's enclosure that may be of sufficient magni-
tude to constitute a risk of electric shock.
The exclamation point within an equilateral triangle is intended to alert
the user to the presence of important operating and maintenance in-
structions in the literature accompanying the appliance.
EMC Notice
Kickback KB12 and Kickback KB15 are Active Speakers for professional use, they can be used in
following electromagnetic environment: residential, commercial and light industrial, urban outdoors.
They are the apparatus Not intended for rack mounting.
• For the Kickback Amplifier, the peak inrush current equals to 4.1A.
FCC Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two condi-
tions: (1)this device may not cause harmful interference,and (2)this device must accept any interfer-
ence received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable pro-
tection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Samson Technologies Corp.
©2016, v2.2
278-B Duffy Ave
Hicksville, New York 117801
Phone: 1-800-372-6766
www.samsontech.com
2
ATTENTION
RISQUE DE CHOC ÉLECTRONIQUE -
NE PAS OUVRIR