Hitachi YUTAKI-M Serie Guia Del Usuario página 3

This section shows you how to setup and run the Room Unit in 3 simple steps:
STEP 1: Installing the Batteries
Note: Please follow the instructions in this section only if the Room Unit screen is blank (no
symbols or digits are displayed). If the room temperature is already displayed move on to Step
2: Setting the Day and Time.
To install the Batteries:
a. Lift up the front cover of the Room Unit to reveal the battery cover and product controls.
b. Remove the battery cover by pressing down and sliding out.
c. Insert the 2 x AA LR6 Alkaline Batteries supplied with the Room Unit, ensuring the correct
orientation (see 'controls Layout' on page 2).
d. After a short pause the Room Unit will display information on the screen and is now ready for use.
e. Replace the battery cover by sliding it firmly back into the front of the Room Unit.
STEP 2: Setting the Date and Time
To set the date and Time:
a. Press the button to begin setting the date.
b. Press the or
month) then press the green
c. Press the or
press the green
d. Press the or
button to confirm. The date is now stored and the Day Indicator will be displayed under
the current day of the week (e.g. 1 = Monday, 2 = Tuesday, etc.)
e. Use the or
Each press of the buttons will change the time by one minute and holding them down will
change the time slowly at first and get progressively quicker.
Note: If this mode is entered accidentally then press the
STEP 3: Running the Built-in Heating Program
The Room Unit is now ready for operation. Press the
will start running. Note: The built-in heating program has been designed to provide normal
comfort requirements, but if you want to customise the settings please see the next section
'Programming the Room Unit'.
The Built-in heating Program
The built-in heating program has 6 temperature level changes per day that can be set between
3.00am and 2.50am the following day - allowing you to maintain the evening temperature after
midnight. Each temperature level can be set between 5°C and 35°C, and adjusted in 0.5°C
increments. The factory default program for heating is as follows.
Monday to Friday
(Day 1 to 5)
saturday & sunday
(Day 6 & 7)
buttons to set the current day of the month (e.g. d01 = 1st day of the
button to confirm.
buttons to set the current month of the year (e.g. m01 = January) then
button to confirm.
buttons to set the current year (e.g. yr09 = 2009) then press the green
buttons to set the correct time then press the green
Period
Time
Temperature
Period
Time
Temperature
setting-up the Room Unit
,
button and the built-in heating program
Programming the Room Unit
1 2 3
6:30 8:00 12:00
21°C 18°C 21°C
1 2 3
8:00 10:00 12:00
21°C 21°C 21°C
button to confirm.
or buttons to exit.
4 5
14:00 18:00 22:30
18°C 21°C 18°C
4 5
14:00 18:00 23:00
21°C 21°C 18°C
3
6
6