Operation & Maintenance - Bostitch F84-114 Manual De Operación Y De Mantenimiento

182223REVA_F84_Manual.qxp:180332REVA
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when loading, operating or servicing this tool. Eye protection is
required to guard against flying fasteners and debris, which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded spectacles
and face shields alone do not provide adequate protection.
1. Pull pusher (026) backwards until it stops on pusher pivots (024). Then rotate pusher (026) into position.
2. Insert 4 sticks of appropriate staples into the magazine (020) from back. Let the staples slide forward to
the front of the magazine (020).
3. Pull pusher (026) back to upright position and gently let the pusher (026) slide forward against the
staples.
4. Put the carton into position.
NOTE: Straighten the center line of carton to the covers A's center line.
5. Press the step board set (044) down by foot until it stops. Then release the step board set (040).
NOTE: If there is not a carton in position, do not press the step board set (044) down.
1. Keep the machine clean.
2. Feed oil on every shaft before operating everyday.
7/30/08 10:56 AM
5
Page 5
OPERATION
MAINTENANCE