Start-Up Procedure - DeWalt DPE3800 Manual De Instrucciones

• Your washer operates at fluid pressures and velocities high
enough to penetrate human and animal flesh, which could result
in amputation or other serious injury. leaks caused by loose fit-
tings or worn or damaged hoses can result in injection injuries.
DO NOT TREaT FlUID INJECTION aS a SIMPlE CUT! See a
physician immediately!
WARNING: Risk of fire, asphyxiation and burning. NEvER fill fuel tank
when engine is running or hot. Do not smoke when filling fuel tank.
• Never fill fuel tank completely. Fill tank to 1/2" (12.7 mm) below
bottom of filler neck to provide space for fuel expansion. Wipe any
fuel spillage from engine and equipment before starting engine.
• Never run engine in doors or in en closed, poorly ven ti lat ed
areas. En gine exhaust con tains carbon mon ox ide, an odorless
and deadly gas.
• DO NOT let hoses come in contact with very hot engine
muffler during or immediately after use of your pressure
washer. Damage to hoses from contact with hot engine
surfaces will NOT be covered by warranty.
cAutIoN: NEvER pull water supply hose to move pres sure washer.
This could damage hose and/or pump inlet.
• DO NOT use hot water, use cold water only.
• Never turn water supply off while pressure washer engine is
running or damage to pump will result.
• DO NOT stop spraying water for more than two
minutes at a time. Pump operates in bypass
mode when spray gun trigger is not pressed.
When the temperature inside the pump rises
too high the thermal relief valve (U) will open
and release a gush of water in an effort to lower
the temperature inside the pump. The thermal
relief valve will then close. If pump is left in bypass mode for
more than two minutes internal components of the pump can
be damaged.
All manuals and user guides at all-guides.com

start-uP ProcEDurE

1. In a well-ventilated outdoor area, add fresh, high-quality, unleaded
2. Check engine oil level. Refer to the engine instruction manual for
3. Connect the water hose to the water source. Turn the water source
4. Verify the filter screen (V) is in water inlet of
5. Connect the cold water source (X) to pump
WARNING: To reduce the possibility of con-
tamination always protect against backflow when
connected to a potable water system.
6. Connect high-pressure hose (C) to pump
7. If applying a chemical or cleaning solution,
U
8. Turn the water source on.
cAutIoN: Risk of property damage. Failure
to do so could cause damage to the pump.
9. Remove all air from the pump and high pressure hose by depress-
10. Prepare engine for first time use, see engine's instruction manual
18
gasoline with a pump octane rating of 86 or higher. Do not overfill.
Wipe up spilled fuel before starting the engine. Refer to engine
instruction manual for correct procedure.
correct procedure.
on to remove all air from the hose. When a steady stream of water
is present, turn the water source off.
pump. The cone side faces out.
inlet.
notE: Water source must provide a minimum
of 5 gallons per minute at 20 PSI.
outlet.
chemicals and
refer to
solvents.
ing trigger until a steady stream of water is present.
for correct procedure.
V
C
cleaning
X