Denon PMA-SA1 Instrucciones De Operación página 7

ENGLISH
i
Input selector switch (INPUT SELECTOR)
Use these to select the program source.
• TAPE-2/MD:
Use this position when using the tape deck, etc.,
connected to the TAPE-2/MD terminals.
• TAPE-1/CD-R:
Use this position when using the tape deck, etc.,
connected to the TAPE-1/CD-R terminals.
• PHONO:
Use this position when using the record player connected
to the PHONO terminals.
NOTE:
Set the EQ POWER switch
• CD-1:
Used to listen a CD player or other component that is
connected to the CD-1 terminals.
• CD-2:
Used to listen a CD player or other component that is
connected to the CD-2 terminals.
• TUNER:
Used to play a component such as an FM/AM tuner or a
TV tuner that is connected to the TUNER terminals.
• DVD/AUX:
Used to play a component such as a HiFi video player, TV
tuner or tape deck that is connected to the DVD/AUX
terminals.
o
Input terminals (INPUTS)
These are input terminals for CD players, turntables,
AM/FM tuners, tape decks or other playback components.
NOTE:
The PHONO input terminals are equipped with a short
pin-plug. Remove this plug to connect a record player.
Store the removed short pin-plug in a safe place so as
not to lose it.
!0
Ground terminal (SIGNAL GND)
Connect the turntable's ground wire here.
NOTE:
This terminal is used to reduce noise when a turntable,
etc., is connected.
It does not provide grounding.
e
to the ON ( ) position.
¢
!1
Recording output terminals (REC OUT)
These are recording output terminals for connection to tape
decks or other recorders.
!2
BALANCED INPUT terminals (BALANCED INPUT)
These are cannon input terminals for connecting a CD player or
other playback component equipped with balanced outputs.
The polarities of the pins are as follows:
Pin 2 : Cold
( – )
Pin 3 : Hot
( + )
!3
Speaker system terminals
(SPEAKER SYSTEMS)
Connect the speaker systems here.
NOTE:
The PMA-SA1's speaker output has a BTL configuration,
so inverted phase signal is fed to the ">" terminal
same as noninverted phase signal is fed to the "<"
terminal. Do not use these terminals to connect a
device (such as an audio channel selector) for switching
between multiple amplifiers or for any type of
connection (speaker matrix connection, etc.) other than
the normal speaker connections (see page 9). Such
connections may result in damage.
!4
AC inlet receptacle (AC IN)
Connect the included power supply cord here.
Do not use any other cord than the provided power supply
cord.
ENGLISH
Pin 1 : Ground
(GND)
7