Alemite 7373 Guía De Servicio página 4

SER 7373
Installation
WARNING
Do not exceed the lowest pressure rating of
any component in the system.
Never point a control valve at any portion of your body
or another person. Lubricant discharged at high veloc-
ity can penetrate the skin and cause severe injury.
Should any lubricant appear to puncture the skin, get
medical care immediately.
Ensure all components are in operable condition.
Replace any suspect parts prior to operation.
Hold the delivery hose securely until the reel is securely
latched or fully retracted. Uncontrolled retraction can
result in personal injury.
Item # Description
27a Screw 10-32 x 1/2 "
27b Retainer, Roller
27c Pin
27d Roller, Long
27e Roller, Short
27f Plate, Roller
27g
Nut, Elastic Stop, 10 -32
Legend:
Parts are not available separately
designates the parts available in Repair Kit 393696
Figure 3 Hose Guide Assembly 340278 - Exploded View
Revision (6-11)
1-800-548-1191-http://www.partdeal.com-info@partdeal.com
1. Connect the delivery hose securely to 90 ° Union (1).
2. Secure the delivery hose to the Sheave Assembly with
U-Bolt (13), Washers (12) and Wing Nuts (11).
3. Rotate the Sheave Assembly to wrap the hose completely
onto the reel.
• The clicking sound is the power spring bypassing the cam
on Spring Arbor (21).
4. Rotate the Sheave Assembly in the opposite direction 3 turns.
• This sets the power spring tension.
5. Feed the end of the delivery hose through Hose Guide
Assembly (27).
6. Install and secure the hose stop.
7. Mount the reel assembly with the appropriate hardware as
required.
8. Adjust the hose stop to the desired position.
9. Attach the connecting hose (with thread sealant) to the
distribution system and to the inlet of the reel as required.
10. Install the control valve (with thread sealant).
11. Pressurize the system and check for leaks.
Checking Spring Tension
Check to ensure the tension on the power spring is sufficient
to properly hold the hose stop against the Hose Guide.
Should the power spring tension require adjustment:
12. Release all pressure within the system.
Notes Qty
motor.
4
Into an appropriate container, operate the control valve
1
to discharge remaining pressure within the system.
2
2
13. Remove the control valve and the hose stop from the delivery
2
hose.
1
14. Unlatch the reel and allow the free end of the delivery hose to
4
pass through the Hose Guide.
4
Double Post Fuel Hose Reel
HINT: Orient the hose to allow its natural curve
to match the Sheave. This reduces torque load on
Power Spring Assembly (16).
IMPORTANT: Allow some slack on the hose
between the U-Bolt and the 90 ° Union.
IMPORTANT: When the hose is fully extended
from the reel, the power spring should be a mini-
mum of 1/2 turn from a fully wound condition.
WARNING
Disconnect the air supply line to the pump's
Alemite, LLC