Getting Started - HAMPTON BAY 213-532 Manual De Instrucciones

OPERATION INSTRUCTIONS:
GETTING STARTED: After installing the fixture, slide the "TIMER" switch to "TEST". Restore power at
the circuit breaker and turn on your wall switch (if applicable). The light will turn on and remain on for
approximately 45 seconds. Then the light will flash 3 times and then turn off. (Note: TEST mode allows you
to conveniently set the motion sensor sensitivity. In TEST mode, the motion sensor will turn on the light
when it senses movement. Four to five seconds after movement has stopped, the light will turn off.)
SETTING MOTION SENSOR SENSITIVITY IN TEST MODE: (Note: Sensitivity directly correlates to
the sensor's detection range.) In TEST mode, slide the "SENSITIVITY" switch to a desired level: "L" for
low, "M" for medium, or "H" for high. From a distance, walk through the coverage area. When the sensor
detects you and the light turns on, note your distance from the fixture. Move away from the fixture and wait
4 to 5 seconds for the light to turn off. Walk through the coverage area again, this time trying a different
approach toward the fixture at different angle. Again, make note of your distance from the fixture when the
light turns on. Repeat these steps, approaching the fixtures down different pathways. Especially, walk
through pathways where you expect high traffic, such as walkways and driveways. After testing various
pathways, decide to increase or decrease the detection range, or to keep it the same. To increase the
detection range, slide the "SENSITIVITY" switch to the next highest level. To decrease the detection range,
slide the "SENSITIVITY" switch to next lowest level. Repeat the steps above. Continue to adjust the
sensitivity level until optimum results are attained.
SELECTING FUNCTION: After setting the sensitivity to the desired level, select the function by sliding to
"TIMER" switch to one of the following positions:
"TIMER"
Switch Function
Position
2
Motion
Sensor
6
DUSK-TO- Dusk-to-
DAWN Dawn
NOTE: To make sure the above functions operate properly, always keep the wall switch in the "ON" position
(including daytime).
At dusk, the motion sensor becomes active. Any movement within the
coverage area will cause the light to turn on. After movement has stopped,
the light will remain on for the preset time limit of 2 or 6 minutes, at which time
the light will turn off. The motion sensor will remain active throughout the
night. At dawn, the motion sensor will deactivate. The motion sensor will
remain deactivated throughout the day. Movement will not cause the light to
turn on.
At dusk, the light will turn on. The light will remain on throughout the night
until dawn. At dawn, the light will turn off. The light will remain off
throughout the day until dusk.
Description
Page 9