Connections; General Operation - Saba JULY CI Manual De Instrucciones

Replace the Remote Control Battery
1� Pull out the battery tray and remove the old battery�
2� Place a new CR2025 battery into the battery tray with correct
polarity (+/-) as indicated�
3� Insert the battery tray back into the slot�
Caution :
– Danger of explosion if battery is incorrectly replaced�
– Replace only with the same or equivalent type�
Precautions Concerning Batteries
• When the Remote Control is not going to be used for a long time (more than a month),
remove the battery from the Remote Control to prevent it from leaking�
• If the batteries leak, wipe away the leakage inside the battery compartment and replace the
batteries with new ones�
• Do not use any batteries other than those specified�
• Do not heat or disassemble batteries�
• Never throw them in fire or water�
• Do not carry or store batteries with other metallic objects as this may cause the batteries to
short-circuit, leak or explode�
• Never recharge a battery unless it is confirmed to be a rechargeable type�

Connections

GB
Use AUX socket
– Use a RCA to RCA audio cable (not included) to connect the TV's audio output sockets to
the AUX (R L) socket on the unit�
L
– Use a RCA to 3�5mm audio cable (included) to connect the audio player's headphone socket to
the AUX (R L) socket on the unit�
124
AUX R
Setting up the FM aerial
Unwind the coiled FM aerial at the back of the CD player�
IMPORTANT:
– You may need to adjust the position of the FM aerial
when tuning the radio to receive the strongest signal�
– Never leave the aerial where it can be pulled by pulled
by young children�
Connect Power
– This unit is designed to operate with an AC power
supply�
– Connecting the unit to any other power source may
cause damage to the unit� Unwind the mains cable to its
full length� Connect the mains plug to a mains socket�
Make sure the mains plug is fully inserted into the mains
socket� The unit is now connected and ready to use�
– To switch the unit off completely, unplug the mains plug from the mains socket�
Note: Ensure all connections are connected before connecting to the mains power socket.

General operation

Standby/ON
When you first connect the unit to the mains socket, the unit will be in STANDBY mode�
button on the remote control or on main unit to switch the main unit ON�
• Press the
• Press the button on the remote control or on main unit to switch the main unit back to
Standby mode�
– Disconnect the mains plug from the mains socket if you want to switch the unit off completely�
– If there is no signal under the CD, USB, BT(Bluetooth) or AUX mode, the unit will automatically
switch off within 15 minutes�
Select Modes
L AUX R
Press the button on the unit repeatedly or switch between CD, USB, FM, BT (Bluetooth) or
AUX mode� The selected mode will show on the display� Alternatively press the CD, USB, FM, BT
(Bluetooth) / AUX buttons on the remote control to select the desired mode�
GB
125