Lubricating The Gearbox; Replacing The Starter Rope And Rewind Spring - Stihl FS 300 Manual De Instrucciones

English

Lubricating the Gearbox

Use STIHL gear lubricant (special
accessory) for lubrication.
1
2
Check grease level about every 100
N
hours of operation.
Unscrew the filler plug (1). If no
N
grease can be seen on the inside of
the filler plug, screw the tube of
lubricant (2) into the filler hole.
Squeeze up to 5 g grease into the
N
gearbox.
NOTICE
Do not completely fill the gearbox with
grease.
Refit the filler plug and tighten it
N
down firmly.
78
Replacing the Starter Rope
and Rewind Spring
Removing the Fan Housing
1
1 1
Take out the screws (1).
N
Remove the fan housing.
N
Replacing the Starter Rope
2
3
4
Remove the spring clip (2).
N
Carefully remove the rope rotor with
N
washer (3) and pawl (4).
WARNING
The rewind spring may pop out and
uncoil during this operation – take care
to avoid the risk of injury.
1
Pry the cap (5) out of the grip.
N
Remove the remaining rope from
N
the rotor and starter grip.
Tie a simple overhand knot in the
N
new rope and then thread it through
the top of the grip and the rope
bushing (6).
Refit the cap in the grip.
N
5
6
FS 300, FS 350, FS 380