DBI SALA 8562894 Manual De Instrucciones Para El Usuario página 7

3.5 BODY SUPPORT: When using the Capital Safety Counterweight Base and Offset Mast is recommended that
a full body harness be worn. For general fall protection use, connect to the D-ring on the back between the
shoulders (dorsal D-ring).
IMPORTANT: What to use for weight - Only 50 lb (22.5 Kg) steel weight-lifting plates are approved for use
with the Capital Safety Counterweight Base. Each plate MUST bear permanent manufacturer's identification
of weight. Plates MUST NOT be more than 1 1/2 inch (38.1 mm) thick with a minimum 1-1/16 inch (27 mm)
center hole. It is required, where possible, to install an equal number of weight plates on each of the 4
weight mount poles. When the specified number of weight plates does not allow this, extra plates MUST BE
installed on the weight mount poles farthest from the mast sleeve.
3.6 CONNECTING TO THE ANCHOR: Refer to instructions for the davit arm.
3.7 NORMAL OPERATION: If a fall has been arrested, the system must be taken out of service and inspected,
see section 5.0.
4.0 TRAINING
4.1 It is the responsibility of all users of this equipment to understand these instructions, and are trained
in the correct installation, use, and maintenance of this equipment. These individuals must be aware of
the consequences of improper installation or use of this equipment. This user manual is not a substitute for a
comprehensive training program. Training must be provided on a periodic basis to ensure proficiency of the users.
5.0 INSPECTION
5.1 BEFORE EACH INSTALLATION: Inspect the counterweight components, and other system components
according to these or other manufacturer's instructions. System components must be formally inspected by
a qualified person (other than the user) at least annually. Formal inspections should concentrate on visible
signs of deterioration or damage to the system components. Items found to be defective must be replaced.
Do not use components if inspection reveals an unsafe or defective condition. Record results of each
inspection in the inspection and maintenance log in section 10.0 of this manual.
IMPORTANT: If this equipment has been subjected to forces resulting from the arrest of a fall, it must be
immediately removed from service and destroyed or returned to DBI-SALA for possible repair. See section 5.2.
5.2 INSPECTION STEPS:
Step 1. Make sure the counterweights will lay flat on the base.
Step 2. Make sure that quick release pins will remain secure when inserted in the pin holes.
Step 3. Make sure that the clamp screws can be securely tightened.
Step 4. Make sure that there are no damaged parts or hardware and there are none that are obviously
damaged or missing.
Step 5. Check for bent, damaged, missing or corroded components.
5.3 If inspection reveals an unsafe or defective condition, remove the unit from service and destroy, or contact
Capital Safety for possible repair.
5.4 USER EQUIPMENT: Inspect each system component or subsystem (i.e. SRL, full body harness, lanyard,
lifeline, etc.) per associated manufacturer's instructions. Refer to manufacturer's instruction supplied with
each system component for inspection procedures.
6.0 MAINTENANCE, SERVICE, STORAGE
6.1 The Counterweight Base components require no scheduled maintenance, other than repair or replacement of
items found defective during inspection; see section 5.0. If components become heavily soiled with grease,
paint, or other substances, clean with appropriate cleaning solutions. Do not use caustic chemicals that
could damage system components.
7