Height Adjustment; Operating Instructions; Switching On And Off - Black and Decker NST2118 Manual De Instrucciones

• Push the handle
completely onto the housing
and position it slightly until it
"snaps" into place (figure 8).
• To adjust the handle up or
down, press in on the button
(g) and raise or lower the
handle.
• The handle should be
adjusted so that your front
arm is straight when the
trimmer is in the working
position.

HEIGHT ADJUSTMENT

• The overall height of the
trimmer can be adjusted by
loosening the collar (h) and
rotating it in the direction of
the arrow shown in figure 9.
• Move the upper housing
straight up or down. When
the desired height is
achieved, tighten the collar
by rotating it opposite of the
direction shown in figure 9.
8
9
h

OPERATING INSTRUCTIONS

WARNING:
to ANSI Z87.1 (CAN/CSA Z94.3) while operating this power tool.
CAUTION:
cord, or string-like objects which could become entangled in the
rotating line or spool. Be particularly careful to avoid any wire which
g
might be bent outwardly into the path of the tool, such as barbs at the
base of a chain link fence.

SWITCHING ON AND OFF

• To switch the tool on, squeeze the trigger lever.
• To switch the tool off, release the trigger lever.
• With the unit on, angle unit and slowly swing the trimmer side to
side as shown in figure 10.
8
Always use proper eye protection that conforms
Inspect area to be trimmed and remove any wire,
10