Fermax DUOX Manual De Instalación página 26

DUO DUO X Pr X Pr X Pr o o o o o g g g g g r r r r r amming
DUO X Pr DUO DUO X Pr
DUO DUO X Pr o o o o o g g g g g r r r r r amming X Pr X Pr
DUO X Pr
DUO DUO X Pr
The call code previously programmed on that
monitor will be assigned to the button (it will be
stored on the amplifier).
Repeat step 4 with all the homes-buttons on the
system.
Note: If in inverse configuration mode you press a
button without having received access to
programming from the terminal, the amplifier emits
an error bop.
5. Exit Programming:
Press the SW1 amplifier's «button programming» button
again.
The amplifier automatically exits programming mode
following 5 minutes of inactivity.
Note:
•
Depending on the range of call codes, you have to
configure the street panel (amplifier) as needed. If
all monitors:
- Have the same block and sub-block address
(BBSSNN) the panel is configured as a sub-block
(or block) with those values.
Pag 26
amming amming
amming amming
amming amming
amming
amming