Installation Guide - AOSmith AO-FM El Manual Del Proprietario

1
2
System Head Mounting Options
Option 1
Measure the distance between
mounting holes on back of system
head. Use this measurement to
determine placement of mounting
holes and mark with a pencil.
3
After marking placement for
mounting screws, use a 7/32" drill
bit to drill holes. Carefully tap plastic
anchors into the holes with a hammer.
Place the mounting screws into the
anchors and mount the system head
to the wall.
Lightly place system head onto cartridge
(do not fully attach) to determine a suitable area
under the sink to mount the system vertically.
Three (3) inches of clearance from the base of the
cartridge is needed for easy cartridge replacement.
The system head must be installed less than three
(3) feet from the COLD-water inlet valve.
Note: Remove system head before
proceeding to step 3.
3 "
Note: make sure mounting holes are level.

INSTALLATION GUIDE

Option 2
Remove the cover from the system head as
shown below (1). With cover removed, place
system head in desired location. Use a pencil
to mark placement of screws (2). Place cover
back on.
1 2
4
Fully connect cartridge to system head by
pushing in and turning the cartridge to
the right until it locks into place.
1 2
NEED HELP? GIVE US A CALL 877.333.7108
2