Wireless Footswitch Operation; Footswitch Battery - Chauvet 4BAR USB Guía De Referencia Rápida

Wireless Footswitch Operation

Power DIP
Switch Switch
The included wireless footswitch provides quick access to preset colors, color-change programs, and sound-activation
through the 4BAR USB microphone.
To use the footswitch:
1. Connect the 4BAR USB to power. Turn the wireless footswitch on.
2. Press <MENU> repeatedly until SEt shows on the display, and press <ENTER>.
3. Use <UP> or <DOWN> to select rF, and press <ENTER>.
4. Use <UP> or <DOWN> to select on, and press <ENTER>.
5. Use <UP> or <DOWN> to set the channel, from rF01–16, and press <ENTER>.
6. Press <MENU> repeatedly until P-- shows on the display, and press <ENTER>.
7. Set the DIP switch channel on the wireless footswitch to match the channel set on the 4BAR USB. (Use the
Switch Channels
8. Press pedal 1 to activate static color controls. When working, all the lights will begin in a static color and Foot
will appear on the Menu display.
9. Use the chart below to activate the desired function.
Pedal
1
(Static Colors, Auto
Programs)
2
(Sound Mode/Strobe)
3
(Blackout)
The 4BAR USB footswitch will work properly in any mode, with a maximum unobstructed distance of
50 ft (15.24 m). You must turn on the rF on the 4BAR USB, set the rF channel, and navigate to Auto
mode before using the footswitch.

Footswitch Battery

The wireless footswitch uses a 9-volt battery located under the battery cover on the bottom of the product, which can be
replaced when necessary.
Battery Replacement
To replace the battery in the wireless footswitch:
1. Turn the power switch to the Off position.
2. Remove the battery cover by removing 2 screws with a Phillips-head screwdriver.
3. Remove the old battery from the housing and unplug it from the leads.
4. Replace with a new 9-volt battery, ensuring that the positive (+) and negative (-) leads correspond to the correct
electrodes on the battery.
5. Place the battery into the housing and cover with the battery cover.
6. Secure the battery cover with the 2 Phillips-head screws.
Do NOT over-tighten the screws!
4BAR USB QRG Rev. 1
QUICK REFERENCE GUIDE
LED
Indicators
image for help)
Action
Tap pedal to activate, then
tap to navigate to desired
function
Tap
Press and hold
Tap
Press and hold
9-Volt Battery
Cover
Function
White
Red
Green
Blue
Yellow
Magenta
Cyan
Auto snap program
Auto fade program
Sound-active mode
Strobe
Blackout on or off
Fade out or in
1 2 3
EN
DIP
4