Remote Control Operation; Testing Your Fan - Craftmade TIM54ABZ Guia De Instalacion

12. Remote Control Operation.

HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
button - used to REVERSE blade direction (fan must be set
on low before reversing blade direction)
button - turns fan OFF
L1 button - turns lower light ON/OFF when pressed once; dims
lower light when pressed and held down
L2 buton - turns upper light ON/OFF when pressed once; dims
upper light when pressed and held down

13. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Locate ON/OFF slider
switch on wall control and set to the ON
position. Test light and dimmer functions with
the L1 and L2 light buttons and then test fan
speeds with different fan speed control
buttons on the wall control. Next, locate
remote control transmitter. Test fan speeds
with the different fan speed buttons on remote
control. Test the light ON/OFF function with the
L1 button on the remote control; repeat with
the L2 button. Test dimmer function by holding
down the L1 button for more than 2 seconds;
repeat with the L2 button. If the remote control
operates all of the functions of the fan and
light, battery has been installed correctly. If the
wall and/or remote controls do (does) not
operate all of the fan/light functions, please
refer to "Troubleshooting" section to solve any
issues.
Fan must be on LOW before setting the fan to
reverse direction. Use "reverse" button to
recirculate air depending on the season.
NOTE: If the remote control interferes with
other appliances, change code switches on the
transmitter (AND the wall control) to another
code. If you do change the code, turn power
off first, remove the battery cover, and, after
setting the new code, go back to the
instructions in the last paragraph of Section 10
(page 9).
page 10
L1 L1 L2 L2