Safety Precaution - Toparc SPOOL GUN Manual De Instrucciones

Thank you and congratulate on using our welding gun and equipment!
In order to serve customers perfectly, please take time to read the operational manual carefully.

SAFETY PRECAUTION

• Before installing the welding gun , please read the safety precautions carefully and know about the equipment
requirements (such as welders, wire feeders, shielding gas etc.) to make sure the correct installation and employment.
• For safety, only can qualified people operate the gun.
• Make sure the rated current works within correct range, if overrated; the welding gun will be damaged easily!
• Ensure the faulty and damaged cable is not used.
• Do not make the gun touch sharp and over-heated work pieces.
• Always wear a work clothes, proper fitted welding helmet and protection products according to the labor protection.
• Keep operator's eyes, face and other parts away from gun head when observe the wire is out or not, in order to avoid
injury by splashing wires.
SPÉCIFICATIONS PRINCIPALES
Rated Welding Current
Duty Cycle
Shielding gas
Wire Diameter
Wire Speed
Spool Cover Diameter
Motor Voltage
Standard Cable Length
Speed Adjust Potentiometer
Cooling System
Changeable Gun Neck
Net Weight (8m)
Connection
Criterion: EN 60974-7
Welding mode: MIG/MAG
Guiding mode: manual
Rated voltage: ≤113V
Rated electrical controlling rate: 24V
INSTALLATION AND OPERATION
• Connect the welding gun with welder
Switch off welder power, make the Euro-central connector connect with wire feeder adaptor, and tighten threaded collar.
Insert plug into receptacle, and tighten threaded collar.
• Choose contact tip
In general, contact tip diameter larger than the wire diameter 0.15~0.2mm.
• Installing wire spool
Press the spool cover button and rotate cover open, loose the spool cover fixing screw (levo). Slide wire spool to it's
shaft, adjust hub tension nut (clockwise damping increase, counterclockwise damping decreases)to make it suitable. Do
not over tighten. Push wire through guides into wire feeding roll. Press the trigger after closed the cover, wire feeding
roll make the wire into the gun tube.
Mild Steel
Stainless Steel
Aluminium
SPOOL GUN
CO2 and mixed gas M21
Straight neck/Goose neck
150A
60%
0.6-0.8mm
0.6-0.8mm
0.6-1.0mm
0~18m/min
φ102mm
DC 24V
4 m
10kΩ(1kΩ/5kΩ)
Air cooling
4.4kg
Euro-central
EN
7