Led Indicators; I/O Terminal Connector - Axis 207 Guia De Instalacion

AXIS 207/207W Installation Guide

LED indicators

Unlit
Wireless
Green
(AXIS 207W)
Red
Amber
Network
Green
Unlit
Green
Unlit
Status
Amber
Red
Green
Power
Amber

I/O terminal connector

The 4-pin I/O terminal connector provides the interface to the following:
Function AXIS 207
Transistor Pin 4
Output
Digital Input Pin 3
GND Pin 2
Auxiliary DC Pin 1
Power Input (5VDC
min 2.5W)
Wired mode.
Steady for connection to a wireless network. Flashes for network activity.
Steady for no wireless network connection. Flashes when scanning for wireless networks.
Steady for connection to a 10 Mbit/s network. Flashes for network activity.
Steady for connection to a 100 Mbit/s network. Flashes for network activity.
No wired network connection, or AXIS 207W in wireless mode.
Steady for normal operation. Can be configured to flash green at intervals whenever the
camera is accessed. See the online help for more information.
When configured for "no flash" on camera access.
Steady during startup, reset to factory default and when restoring settings.
Slow flash for failed upgrade.
Normal operation.
Flashes green/amber during firmware upgrade.
AXIS 207W Description
Pin 4 With a maximum load of 100mA and a
maximum voltage of 24V DC, this output
has an open-collector NPN transistor
with the emitter connected to the GND
pin. If used with an external relay, a
diode must be connected in parallel with
the load, for protection against voltage
transients.
Pin 3 Connect to GND to activate, or leave
floating (or unconnected) to deactivate.
Pin 1
Pin 2 Connected electrically in parallel with
(5VDC the power adapter, this pin provides an
min 3.5W) auxiliary connector for mains power to
the unit. It can also be used to power
auxiliary equipment, max 50mA.
Page 5
Pinouts
The I/O terminal pins on
the AXIS 207 and AXIS
207W are numbered as
shown below.
AXIS 207
4
1
AXIS 207W
1 4