Appliance Description - Beurer ELLE HLE 40 Instrucciones Para El Uso

WArnInG: Fire hazard
There is a risk of fire if the device is used incorrectly or if it is not used according to these operating
instructions.
For this reason, the massage device must only be operated as follows:
• Never leave the device unsupervised, particularly if children are around.
• Never use the device under covers, such as blankets or pillows.
• Never use the device in the vicinity of petrol or other easily flammable materials.
CAUTIon: Disposal
Follow local regulations regarding the disposal of materials. The appliance should be dispo-
sed of according to Regulation 2002/96/EC-WEEE (Waste Electrical and Electronic Equip-
ment). In case of queries, contact the municipal authorities responsible for waste disposal in
your area.

3. Appliance description

1. Base station
2. Charger contacts
3. Base station protective cap
4. Base device/applicator
5. Indicator lamp
6. Fill level display
7. Protective cap for applicator
8. Warm wax cartridges (2)
9. On/Off switch
4. Operation
• Remove the packaging.
• Check the device, power supply and cables for
damage.
• Connect the device to the mains power. The
device must be switched off at this time.
• Route the cable safely so that there is no risk of anyone tripping over it.
• Switch on the device using the On/Off switch.
• Place the applicator on the base station and insert the second wax cartridge into the separate heating
chamber as shown in the image.
• The indicator lamp flashes while heating is taking place. Once the wax has heated fully, the indicator
lamp then remains continuously lit. This process lasts approx. 25–30 minutes.
• As soon as the wax is hot, roll the wax roller until it rotates without any problems.
• If you are using a warm wax hair remover for the first time, please refer to the instructions to ensure you
are using it correctly.
• In order to become accustomed to the hair removal system and to ensure that you are not allergic to it,
it is preferable to start with a small area on the lower part of the leg. Then wait 24 hours before carrying
out the complete hair removal process.
• The skin must be clean and dry prior to carrying out hair removal.
noTE
• The wax cartridge contains 50 ml wax. This quantity is sufficient for two half legs and a small
number of follow-up treatments. The more practice you get the less wax you will need to use.
• In order to ensure optimum hygiene and cleanliness, the wax roller and the warm wax cartridge
have been designed for single use and must be disposed of following use. Doing so prevents
infections and inflammations.
• Never remove hair straight after a bath or shower; wait approx. two hours to ensure the skin is not
irritated.
7
4
5
2
9
3
1
6
9
8