JBL PRO FLORA m501 Manual Del Usuario página 21

11 Connection cable for solenoid valve
12 JBL Test Kit permanent CO
11.1 Step by step installation
1. First attach, where available, the extensions to the JBL Taifun CO
according to the height of the aquarium.
Rinse the reactor in lukewarm water and place it vertically in the aquarium in a location
with a slight current of water. The upper edge should be approx. 2 cm under the surface of
the water. The slits of the individual modules should be as free as possible from obstruc-
tion by plants or decorations.
u504 only:
Rinse the CO
2
CO Hose. Attach the diffuser where there is gentle water movement as close as possible
2
to the bottom of the aquarium.
2. Installation of the bubble counter (8):
Select a suitable place to fit the bubble counter where it can be easily observed. Install the
bubble counter (8). The bubble counter can either be attached using suction pads (e.g. to
the outside of the aquarium) or to a wall or surface of a piece of furniture with the enclosed
screws. Cut the CO
screw connection of the bubble counter. Make sure the supply hose is attached to the
connection with the long pipe in the bubble counter. Unscrew the lid of the bubble counter
and fill it up to 2/3 with water before closing again. In case the check valve was demounted
during the opening, make sure that all parts are correctly reassembled (see drawing on the
separate packaging of the bubble counter).
Note: When installing without a bubble counter, a separate check valve, which is not in-
cluded in the set, must be mounted.
u501, u501edition 2018, u502, m501, m502.
Install the CO
2
enclosed.
m503, m2003:
Select a suitable place to position the pH computer (7) where it can be easily observed.
Connect the solenoid valve of the pressure regulator (6) with the enclosed valve cable to
the connection "valve" of the pH computer (7). The connectors of the pH computer and the
plug connection of the valve cable are configured in such a way, that an incorrect connec-
tion is not possible.
3. For the CO storage bottle, select a place with a stable base that is out of the reach of
2
children (e.g. cabinet under the aquarium). Insert the m500 refillable storage bottle (1) into
the stand. The m2000 refillable storage bottle (2) and the disposable u500 storage bottle
(3) are free-standing. Position the bottle in the place selected.
4. Connect the pressure regulator to the storage bottle:
u501, u504, u502 CO
Briskly screw the pressure regulator (5, 6) with the internal thread on the back onto the
external thread of the disposable storage bottle (3). After a few turns, a brief hissing noise
will be heard. Continue to turn briskly until you feel resistance. Then turn about half a turn
more until the fitting is hand-tight.
plus pH CO
2
diffuser JBL ProFlora Taifun P in lukewarm tap water and connect it to the
hose (10) to the correct length and attach the free ends to the hose
2
permanent test (11) in the aquarium in accordance with the instructions
kits:
2
permanent test
2
UK
Passive Reactor (9)
2
19