Technical Specifications - HT Instruments HT20s Manual De Instrucciones

USER MANUAL
Professional voltage detector HT20s
1. Safety precautions and procedures
Please follow the herewith indications before and during
the performance of any test with the instrument:

An improper use can damage the
instrument and/or its components or
injure the operator

Avoid using the instrument in rooms
where explosive gas, combustible gas,
steam or excessive dust are present

Do not perform any test if you notice
anomalous
breakages,
leakages of battery liquid on meter

Do not perform any test exceeding the
declared voltage conditions

Do not perform measurements under
environmental conditions
the declared limits

Do not perform any voltage detection
with operator's hand beyond the hand
safety protection
2. Introduction
HT20s meter can perform AC voltage detection with visible
LED red and acoustic buzzer indications. A white LED is
can be also activated.
3. Features
 AC voltage detection with and without contact
 AC voltage detection on conductive and insulated parts
 Auto Power OFF function after 5 minutes
 Visible red LED and acoustic buzzer indications
 White torch LED with ON/OFF key
 Practical pen clip and very small size
 Meter suitable for any electrical installer
CAUTION
conditions such
deformations, fractures,
exceeding
4. Description
1 Voltage detection sensor
2 Reference mark for CAT IV measurements
3 Hand safety protection
key for switch on the instrument and the
4
white LED
5 Pen clip
6 White LED torch
7 Fit part for battery cover sleigh
8 Battery cover sleigh
5. Operating instruction
Consider the herewith steps for a correct use:
1. Switch on the instrument by pressing
2. Perform an initial test with meter on an energized
circuit. Replace internal batteries if the red LED do not
turn on and/or the buzzer do not sound
3. Position the sensor close to or in contact with the point
under test then verify that the red LED is on and buzzer
sounds continuously as evidence of voltage detection.
Do not perform test with the hand beyond the hand
safety protection and move not insulated wires
beyond the CAT IV reference mark (see part 2 of
picture)
4. If necessary press
5. The instrument switch off automatically after 5 minutes
of idleness
as
6. Batteries replacement
Follow the herewith steps to replace internal batteries:
1. Remove the meter from any voltage source
2. Perform a small pressure on battery cover sleigh (see
part 8 of picture)
3. Shift the battery cover sleigh from the meter
4. Replace the batteries with new ones of the same type
and pay attention to keep to correct polarity indication
5. Fit the battery cover sleigh to the meter
6. Used batteries must not be disposed of as urban waste
CAUTION: this symbol indicates that the
equipment and its accessories shall be subject
to a separate collection and correct disposal

7. Technical specifications


Voltage reference range: 100  1000V AC to ground

Frequency reference range: 50/60Hz

Meter indications: visible LED and acoustic buzzer

Safety: IEC/EN61010-1

Category of measurement: CAT IV 1000V

Pollution degree: 2

Batteries: 2 x 1.5V alkaline type AAA IEC LR03

Working temperature: -10°C  50°C (14°F  122°F)

Working humidity: -1040°C;<75%HR;

Dimensions: 160(L)x26(W)x20(H)mm;6(L)x1(W)x1(H)"

Weight (included batteries): 48g (0.1lb)
key
key to turn on the white torch
40  50°C <45%HR
Release EN 3.02 – 30/03/2015