How To Operate - Audiolab LIVE AN16 Manual Del Usuario

8. HOW TO OPERATE

1. Above all, it is necessary to confirm power
voltage.
2. Make sure this appliance power switch is off
when connecting the plug of power cord with
outlet.
3. Set easy controls to the positions stated
belows to avoid lord blasts, Loud blasts may
couse damage for your speaker system or you
rears when you are wearing headphone. Mas-
ter faders L/R, Sub faders AUX, Effect fader
and Each channel faders.
• Gain control: Turn to the left completely.
• Hi, Mid, Low: Turn to the center position.
• Aux 1-2 & Effect control: Turn to the left com-
pletely.
• Pan control: Turn to the center position.
• Set other turn to the left completely.
4. Push power switch marked(1), then the LED
9. INSTALLATION
FIGURE 1
UNBALANCES 1/4" PLUG
will be turned on when start working.
5. Set Master faders L-R to the position be-
tween min & mid, after working.
6. Set a certain Channel faders which you want
to use to the position between min and mid.
After that, Connect input section with exter-
nal source.
7. To make sound thur external sources, turn
the Gain control to the right.
8. Adjust tone controls in accordance with your
taste.
9. Adjust between Effect fader control towards
max from min & effect control to the right,
when you want to get echo effect a certain
channel, after set a certain channel, adjust
delay control & repeat control, then you can
get various echo effect sound.
TIP: POSITIVE (hot+)
SLEEVE GROUND (shield)
P. 11
- AUDIOLAB LIVE AN16
English version