Clemsa MUTAN-II nt Manual Tecnico página 3

CLEMSA
TECHNICAL MANUAL FOR
MUTAN-II
MODELS NT
KEEP THIS DOCUMENT IN A SAFE PLACE, AS
YOU WILL NEED IT TO REQUEST ADDITIONAL
TRANSMITTERS
INSTRUCTIONS
Check that the battery is inserted according to the indicated
polarity.
PROGRAMMING
Stand near the Receiver in order to be able to hear the beeping
tones it emits during the process.
- RECORDING ON AN INSTALLATION'S FIRST TRANSMITTER.
Press down the programming button on the Receiver. The Receiver
will emit two short beeps to indicate that it is ready to record a new
code.
Press any of the buttons on the Transmitter.
The Receiver will emit a short beep to indicate the acceptance and
recording of the code.
If, during the process of recording codes, the Receiver emits three
beeps, that means that the Transmitter has already been used
previously. The Receiver will exit recording mode and it will be
necessary to restart the process.
In order not to exit recording mode, press any of the buttons on
a Transmitter which was not the last one recorded on.
The Receiver will emit three beeps to indicate the end of the process.
The Receiver will also exit recording mode once 30 seconds have
passed since the recording of the last Transmitter, emitting
thosesame three beeps.
- RECORDING OF SUCCESSIVE TRANSMITTERS
(if this option is installed on the Receiver)
Take a Transmitter that is in use at the installation.
Press buttons 1 and 2 on the Transmitter simultaneously, and you
will see the LED flash more slowly.
The Receiver will emit two short beeps to indicate it is ready to
record a new code.
Take the new Transmitter to be recorded and press any one of the
buttons. The Receiver will emit a short beep to indicate the
acceptance and recording of the code.
MADE IN SPAIN If, during the process of recording codes, the Receiver emits three
beeps, that means that the Transmitter has already been used
previously. The Receiver will exit recording mode and it will be
necessary to restart the process.
To exit recording mode press any one of the buttons. The Receiver
will emit three beeps to indicate the end of the process. The Receiver
will also exit recording mode once 30 seconds have passed since
the recording of the last Transmitter, emitting those same three
beeps.
Press the button corresponding to the Receiver's activation channel
to send the coded signal. The LED will light up for as long as you
continue to press the button.
Each time you press it the Transmitter will transmit a different
algorithmic code.
Replace the battery when the LED starts to flicker on pressing the
Transmitter button.
Caution: Risk of explosion in case of replacement of the batteries by
other incorrect type. Dispose of batteries in a responsible manner.
Place them in their appropriate container.
TECHNICAL CHARACTERISTICS
The manufacturer declares, on its own responsibility, that this
apparatus is in compliance with Directive 99/05/EC, of the
European Parliament and Council, of 9 March, 1999, transposed
into Spanish legislation through Royal Decree 1890/2000 dated
20 November.
Complete Declaration of Compliance at www.clemsa.es
© CLEMSA 2015 -
USE
Power: 6Vcc (2 CR2032 batteries)
433.920 MHz – 868.350 MHz
Frequency:
Depending on the model
CLEM, S.A.U.
Avda. de la Fuente Nueva, nº 12,
28703 - S.S. Reyes (Madrid)
www.clemsa.es - clemsa@clemsa.es
CLEMSA
Edición para WEB 10-2015