After Use; Troubleshooting - Holmatro BMC1 Manual

EN
4 Preparation for first use
4.1 Check the mains connector
• Check the mains connector for completeness and damage. Do not use the mains connector if it is
damaged; in that case contact the Holmatro dealer.
• Carefully read all instructions and safety regulations of the mains connector.
• Carefully read all instructions and safety regulations of the Holmatro Greenline rescue tool that you
want to use.
5 Operation
5.1 Connect the mains connector to the tool
• Slide the adapter of the mains connector in the battery pack fitting / adapter fitting of the tool until
the adapter lock snaps tight.
• Insert the power plug of the mains connector into a power outlet with the correct voltage and
frequency. See the electrical specifications on the model plate.
The green LED on the power indicator label will light up, to indicate that the power is on.
NOTE
Only use approved extension cables that are in perfect condition. The minimum cross
section is 3 x 2.5 mm
5.2

After use

• Disconnect the mains connector from the power outlet.
• Remove the adapter of the mains connector from the tool.
• Check the mains connector for completeness and damage. Do not use the mains connector if it is
damaged; in that case contact the Holmatro dealer.
• If necessary, clean the mains connector.
• Carefully store the mains connector. See the instructions in section 7.5.
6

Troubleshooting

6.1 General
Consult the Holmatro dealer if the listed solutions do not give the desired result, or in case of other
problems. For malfunctions or repair, always specify the model and serial number of the equipment.
6.2 The mains connector does not supply power
/i
Possible cause
No power supply; the green LED on the
power indicator label does not light up.
26
2 .
Solution
Check the power supply.
916.001.297_002 BMC1 / BMC2