Truper COMP-POR-2.5 Instructivo página 13

OPERATION
Air Filter: Screw the air filter (included) onto the port in the
compressor side. Do not operate the compressor if the air
filter has not been previously set in place.
Switch: The switch shall be in the OFF position when plugging
or unplugging the cable from the power outlet.
Regulator: The regulator controls the amount of air pressure
released from the hose outlet.
Safety Valve: When the outlet valve is completely closed the
safety valve is activated to release air pressure.
ALERT: If the unit has wheels included never use the handle to
carry or lift it from the ground.
LUBRICATION
This product does not use oil, thus it does not need lubrication
to operate.
BREATHING PROCEDURE
WARNING Do not connect chucks or any other tool to open
the hose end until the unit has completely started and the
inspection is positive.
Do not operate the compressor before reading
WARNING
the instructions; otherwise it could be dangerous using it.
1. Turn completely the regulator to the right to open the
airflow.
2. Turn off the switch and connect the cable.
HUMIDITY IN THE COMPRESSED AIR
Humidity produced by compressed air can be observed, drops
are present when air is coming out from the compressed air
pump.
Humidity will increase when humidity is high or the
compressor is under continuous use. Using a paint gun or any
other substance makes water be transported through the hose.
Then it will come out through the gun as drops combined with
the material to be spayed.
This condensation will cause spaces with water.
WARNING
If working with sand, the material could get hard and clog the
gun and it will stop working. A filter in the air-line, set as close
as possible to the gun could eliminate the humidity.
4
Switch
SAFETY VALVE
Do not remove or try to adjust the safety valve.
WARNING
This valve shall be inspected regularly and under pressure.
Pull the ring with your hand. If air comes out after releasing
the ring, or, when the valve is stuck and it cannot be moved
with the ring IT SHOULD be replaced.
PRESSURE REGULATING KNOB
1. This knob controls the air pressure.
2. Turn the knob to the right to increase air pressure. When the
desired pressure is reached, press the knob down to adjust
again.
3. To diminish air pressure turn the knob to the left.
PRESSURE REGULATING KNOB