Dirt Cup; Filters - Hoover T Serie Manual Del Proprietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

dirt cup

when to empty
4.2 To maintain optimal performance, empty the dirt cup before the dirt cup
reaches the max line (A). Place the vacuum in the upright position before
removing the dirt cup.
To reduce the risk of injury from moving parts, unplug vacuum before
servicing. Do not use vacuum without dirt cup or filters in place.
Very fine materials, such as face powder or cornstarch, may seal the filter
and cause a reduction in performance. When using the vacuum for this
type of dust, empty the cup and clean the filters often.
how to empty
4.3 Press dirt cup
release button (A) and
pivot cup out.
4.4 Hold dirt cup over
trash receptacle, push
dirt cup door release
lever (B) to open dirt
cup door (C).
Close dirt cup door (C).
Press firmly to secure
at front (D).
4.5 Place bottom of dirt cup into vacuum body first. Pivot dirt cup into vacuum
body and press firmly until it locks into place.

filters:

when to clean
To maintain optimal performance, filters should
be cleaned at least every two months under
normal use.
rinsable filter: how to clean
Remove dirt cup as described in Fig. 4.3.
4.6 Pull up on dirt cup latch (A) to open.
4.7 Pull on the filter to remove Rinsable Filter.
Hold filter under running water for two minutes to
remove dirt and debris. Squeeze filter twice while
underwater. Remove from water and squeeze a
final time to remove excess water.
IMPORTANT
Allow filter to dry completely before replacing.
Dry filter on edge so air circulates on both sides
of filter. This may take up to 24 hours.
Replace filter, tab side out.
Close lid securely by pushing at (B) until it clicks as
shown in Fig. 4.6.
Replace dirt cup as described in Fig 4.5.
CAUTION
!
4.3
!
4.4
A
b
D
!
To reduce the risk of injury from moving parts,
unplug vacuum before servicing. Do not use
vacuum without dirt cup or filters in place.
4.6
b
what to buy: rinsable filter
When used and maintained properly, your Rinsable
Filter should not need replacement within the
warranty period. If desired, additional filter is
available at Hoover.com or call 1-800-944-9200.
Ask for Hoover
9
Actual model may vary from images shown.
4.2
4.5
C
CAUTION
4.7
A
®
Part No.303173001.
A
!

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Windtunnel uh70120Windtunnel t serieWindtunnel max

Tabla de contenido