Operating The Brushcutter; Regular Maintenance; Air Filter; Spark Plug - FUREKY BC4320i Manual Del Propietario U Operador

OPERATING THE BRUSHCUTTER

FUREKY brushcutters are designed and tested to cut nearly all grasses, thick weeds and brush. As you
continue to use the equipment, many tasks will become easier.
CAUTION-Adjust the debris shield to a position that does not make contact with the blade or trimming line,
and shields the operator from thrown debris.
CAUTION-Read the SAFETY INSTRUCTIONS concerning the proper use of the brushcutter on page(US-1).
CAUTION-Observe all warnings that appear on the brushcutter.
CAUTION-Use only the correct blade approved for the task and the machine.
CAUTION-Always use the Shoulder Hanging Strap when operating a brushcutter with a metal blade. The
brushcutter must be positioned to the right side of the operator when used with a metal blade.
CAUTION-Always make certain the blade is installed to rotate in the proper direction and that all holding
and fastening parts are correctly secured.
CAUTION-Remove the holding tool ( 6mm pin) before operating the equipment!
CAUTION-Do not continue to use a blade that is dull, damaged, or that vibrates during use. Whenever a
cutting blade becomes clogged with debris, immediately stop the machine and clean the blade.
CAUTION-When cutting heavy blush or small trees, use the proper method to avoid dangerous " KICK-
BACK "(see sketch).
No Kick-back Zone
CORRECT

REGULAR MAINTENANCE

AIR FILTER

The air filter should be cleaned each time the brushcutter is used. (Or
more often with extreme conditions.) Remove the filter cover and take
out the element. Wash the element in kerosene or warm detergent,
then squeeze it dry. Apply oil (#30 wt.) to foam, removing all excess oil.
Assemble and reinstall the element and filter cover.

SPARK PLUG

The spark plug should be removed from the engine and checked after
each 25 hours of operation. The tips can be cleaned with a stiff brush.
Adjust the gap to 0,6-0,7mm (see sketch). Replace the spark plug if it
is oil_fouled or damaged, the average spark plug life is approximately
100 hours.
CAUTION-Do not over_tighten the spark plug. The correct torque is
10.7-16.6N m(100 -160 kgf
•
Direction Direction
of Motion of Motion
cm)
•
— US-6 —
DANGER
Kick-back Zone
INCORRECT
Knob
Tips
Filter Cover
Foam Element
0.6-0.7mm