Enter playback mode and the playback icon will appear in the top left corner. From here you will
be able to select a video to playback, using the up and down buttons and OK to play the selected
video.
Set Menu:
Enter the menu and go through all options to set up the camera as required. In the menu you can
enable features and select language.
To change Video Settings when in video mode, press the MENU button from the video record
mode. Set your video settings and press MENU again to exit.
YOU MUST Activate Video Loop recording to allow for videos to continue to write, or once SD
card is full, recording will stop.
USB Connection:
Two modes are available -
1. USB Disk. This is the default mode for recording and will allow you to access the recordings.
2. PC Camera. This is for viewing through your PC, when connected. You can also use the
camera to then record direct to PC (whilst connected).
Battery Charge Description:
The charging time is about 3 hours to fully charge the battery.
Battery indicator in the bottom right corner of screen shows the battery status.
1.Plug in Power Adaptor to charge and use when driving for on board charging. (We recommend
unplugging when leaving the car for long periods to avoid risk of draining car battery).
2. Use PC-USB charging cable and charge the device up before a journey. (Select Charge mode
when connecting to PC).
Set Up
First Install the Camera on your windscreen. Do this by screwing the camera into the mount and
then stick the mount to the desired part of the windscreen and push the plastic clip on the mount
to lock the position.
DO NOT Mount the dash camera in a place where it will obstruct the drivers view when driving.
Use the illustration below as a guide for installing your Proze Camera.
Do not place in the red
zone.
5