Publicidad
Register outlet must be cut in wall before furnace is installed.
On installed furnace, remove furnace in order to cut hole in wall
for register outlet.
1.
Cut hole in the rear wall 8 1/4" (210mm) high by 11 1/2"
(292mm) wide. The lower edge of the hole is to be 45"
(1143mm) above the floor plate as shown in drawing.
Page 2
Figure 1
There are two knock-outs on the inner casing of the furnace.
2. Remove outer knock-out (4 5/8" x 9 1/2") (117mm x 241mm)
from the inner casing.
3. Remove inner knock-out (4 5/8" x 9 1/2") (117mm x 241mm)
from the inner casing.
Note:
You may have to use a drill and/or snips to remove the
knockouts.
CAUTION: Always wear protective gloves and eyewear when in-
stalling or performing maintenance on this product.
4.
Install header plate assembly and furnace according to Instal-
lation Instructions and Owner's Manual.
The rear register kit is to be attached to the furnace from within
room that is to be heated by the rear register.
5. Insert 5" x 9 1/2" (127mm x 241mm) boot through hole in
the wall and align six clearance holes on the boot with the six
screw holes on outer shield. Attach the boot to the outer shield
with (6) No. 10 x 1/2" (13mm) screws provided.
Figure 2
Figure 3
23892-0-0807
Publicidad
