Tabla de contenido
Publicidad
1
3
4
5
6
3
1.
Turn the air conditioner on and off.
Power:
Press the COOL button to COOL mode.
2.
Cool:
3.
Use these buttons on the control
and
:
panel and remote to increase or decrease the
Set Temperature or Timer. Temperature range:
61 ~88
or 16
4. Sleep:
Press the SLEEP button, all of the
display lights will turn off after a while, but the
Sleep light is always on. In SLEEP mode, the air-
conditioner will automatically adjust the tempera-
ture and fan speed to make the room more comfor-
table during the night. The set temperature will
automatically raise every 30-60 minutes
and at most change six times until the set
temperature is 81 or 82
2
7
8
9
10
~31 .
.
5. Timer:
Use these buttons on the control panel
and remote to set the Timer.
Timer Off: The timed stop is programmed by
pressing TIMER button. Set the rest time by
pressing the button
time displayed is to your demand then press
TIMER button again.
Timer On: When the unit is off, press TIMER
button at the first time, set the temperature with
pressing the button or
button at the second time, set the rest time with
pressing the button or
button at the third time, confirm the setting, then
the rest time to next automatical switching-on
could be read on the display of the machine.
It can be set to automatically turn off or on
Note:
in 0.5-24 hours. Each press of the
buttons will increase or decrease the timer. The
Timer can be set in 0.5 hours increment below
10 hours and 1 hour increment for 10 hours or
above. The SET light will turn on while setting.
To cancel the set function, press the TIMER
button again.
In AUTO mode the unit automatically
6. Auto Mode:
chooses the mode of operation(COOL,DRY or
FAN). In this mode the temperature will be set
automatically according to the room temperature
(tested by the temperature sensor which is
incorporated in the indoor unit.).
Press the FAN SPEED button to
7. Fan Speed:
choose the fan speed options. You can choose
Hi, Med, Lo or auto speed in COOL mode and
choose Hi, Med, Lo in FAN mode.
To press the DISPLAY button, it can
8. Display:
switch off/on all lights or LED display.
9.
When the unit is in ECO mode, the light
Eco:
will turn on. In ECO mode, the unit will turn off
once the room is cooled to the user set temperature.
The unit will turn back on when the room
temperature rises above the user set temperature.
Before the compressor starts, the fan motor will
run for a while, then it will stop for a while, and will
repeat to provide a much more comfortable feeling
and save energy.
Press the Fan Only button to FAN
10.
Fan Only:
ONLY mode.
9
or
until the rest
. Press
TIMER
. Press
TIMER
Publicidad
Tabla de contenido
