HIKVISION DS-PD1-EB-WS2 Manual Del Usuario

DS-PD1-EB-WS2
UD09712B-A
Diagram References
1 Appearance Description
2 Register Panic Button
Register Detector
1.Make the security control panel enter the register mode.
Note: The distance between the security control panel and the detector
should be less than 50 cm.
1
flashing red and green.
APP Store
1. Log in to the and input" Hik-Connect" to search the mobile
client. Download and install Hik-Connect to your phone.
3. Power on the security control panel.
4. Log in the Hik-Connect and tap the icon"+" at the upper-right coner of the
Hik-Connect page to add the security control panel. You can scan the QR code
on the device rear panel or on the package box, or input the device serial No.
3
LEDs: General LEDs
D (i) From power up: Not registered
(iii) 8 x Flashed: Registered
(vi) Control panel has not received the signal from HUD
Yes
Red, Amber, Green
Two-way wireless technology Yes
Two-way wireless technology
One push to learn Yes
Transmission method Fully encrypted rolling code
-10°C to +40°C(Ce )
Dimensions(H x W x D) 70 x 30 x 20 mm
Electrical ＆
Transmission frequency 433MHz, FM transceiver
Range in open space 300m
CR1/3N
3.0 V
Threshold 2.1V +/- 5%
whilst, for safety reasons, having limited output current.
1
Appearance
Indicator
3
G G
R R
(i) Slow flashing (ii) Fast flashing
Product Information
User Manual
COPYRIGHT ©2018 Hangzhou Hikvision Digital Technology Co.,Ltd.
ALL RIGHTS RESERVED.
About this Manual
due to firmware updates or other reasons.
Please use this user manual under the guidance of professionals.
Trademarks Acknowledgement
owners.
This product and - if applicable - the supplied accessories too
are marked with "CE" and comply therefore with the applicable
Hangzhou Hikvision Digital Technology CO.,Ltd.
2
R=Red G=green
G
R
R
G
(iii) (iv)
FCC Information
compliance could void the user's authority to operate the equipment.
FCC compliance: This equipment has been tested and found to comply with the limits for a Class B digital device,
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minimum distance 20cm between the radiator and
your body.
1. This device may not cause harmful interference.
No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
G G
R
(v) (vi)
For electrical products sold within the European Community. At the
end of the electrical products life, it should not be disposed of with
your local Authority or retailer or recycling advice in your country.