Technical Parameters - Elko EP iNels GSM3-01M Manual De Instrucciones

Technical parameters

Communication
Communication interface:
GSM network (Quad-band):
Transmitter output power:
Number of supported calls:
Number of informative SMS:
Number of telephone numbers:
LED indication - operation
state / fault in BUS:
Output for antenna:
Power supply
Supply voltage / tolerance:
Rrated current:
Suppy voltage indication:
Connection
Terminals:
Operating conditions
Operating temperature:
Storing temperature:
Protection degree:
Overvoltage category:
Pollution degree:
Operation position:
Installation:
Design:
Dimensions and weight
Dimensions:
Weight:
* Max Tightening Torque for antenna connector is 0.56 Nm.
TECHNICAL SUPPORT | E-mail: support@inels.com | Mobil: +420 778 427 366 | Tel.: +420 573 514 276, +420 573 514 211 | Fax: +420 573 514 227 | www.inels.com
Made in Czech Republic
GSM3-01M
system BUS EBM
850/900/1800/1900 MHz
2 W for GSM 900, 1 W for GSM 1800
8 incoming, 8 outgoing
32 incoming, 32 outgoing
up to 512
LED STATUS
SMA connector *
27 V DC, -20 / +10 %
250 mA (at 27V DC) / max. 1 A
green LED Un
max. 2.5 mm 2 / 1.5 mm 2 with sleeve
-20 .. +55 °C
-30 .. +70 °C
IP20 devices, IP40 with cover in switchboard
II.
2
any
to DIN rail EN 60715
3-MODULLE
90 x 52 x 65 mm
132 g
ELKO EP, s.r.o. | Palackého 493 | 769 01 Holešov, Všetuly | Czech republic | e-mail: elko@elkoep.com
Warning
Before the device is installed and operated, read this instruction manual carefully and with full
understanding and Installation Guide System iNELS3. The instruction manual is designated for
mounting the device and for the user of such device. It has to be attached to electro-installation
documentation. The instruction manual can be also found on a web site www.inels.com. Attention,
danger of injury by electrical current! Mounting and connection can be done only by a professional
with an adequate electrical qualifi cation, and all has to be done while observing valid regulations.
Do not touch parts of the device that are energized. Danger of life-threat! While mounting,
servicing, executing any changes, and repairing it is essential to observe safety regulations, norms,
directives and special regulations for working with electrical equipment. Before you start working
with the device, it is essential to have all wires, connected parts, and terminals de-energized. This
instruction manual contains only general directions which need to be applied in a particular
installation. In the course of inspections and maintenance, always check (while de-energized) if
terminals are tightened.
2/2