Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SHORT CORD INSTRuCTIONS
•
a short power cord is provided to reduce risks resulting
from becoming entangled in or tripping over a longer
cord.
•
Longer, detachable power supply cords or extension cords
are available and may be used if care is exercised in their
use.
•
If an extension cord is used, the marked electrical
rating should be at least as great as the electrical rating
of the appliance. If the appliance is provided with 3-
wire, grounding type cord, the extension should be a
GROUNDING TYPE 3 - WIRE CORD. The longer cord should
be arranged so that it will not drape over the counter-
top or table top where it can be pulled on by children or
tripped over.
uSE
Before use
•
Remove all packaging from the kettle and power base.
•
Remove any labels from the outer stainless steel surfaces.
•
Remove the filter (fig. 1) and wash with water (fig. 2).
1
c
c
a
a
b
b
Refer to page 5 " Removing the filter".
•
Fill the kettle and boil.
•
The boiled water should be discarded and the kettle rinsed
out with cold water.
This procedure should be carried out three times, to
remove any manufacturing dust, etc.
•
After the kettle has been rinsed out, re-fit the filter (fig.
3).
3
a
2
b
1
2
Power base with 360° access
With the specially designed power base and central connector,
you can now set the kettle on the base at any angle, from any
position.
•
Release cord from storage base and adjust length by
winding around the base to give the correct cord length
to reach the plug socket to be used (fig. 4).
4
•
Do not leave loose cord hanging over the edge of work
surfaces.
Filling
•
Remove the kettle from the base unit before filling.
•
Open lid and fill kettle to desired level.
c
Do not fill with less than 10,14 fl.oz. (0,3 litre) of
water to prevent the kettle running dry while operating;
misuse of this kind will shorten the life of the element.
1
1
Do not fill with more than 57,48 fl.oz. (1,7 litres) of
water (up to the MAX level). If the kettle is overfilled,
there is a risk that boiling water may be ejected
2
causing burns.
Switching on
•
Plug the power base into the mains socket.
•
Place kettle on power base.
•
Press the ON/OFF switch down (fig. 5) to switch the kettle
on.
•
The pilot light will switch on.
•
The kettle will automatically switch off once the water
is boiled (the ON/OFF switch will click upwards and the
lights will switch off ).
5
•
To turn the kettle off before the water boils, you may move
5
use
en
2
Publicidad
Tabla de contenido
