BEFORE USING THE APPLIANCE, PLEASE READ
Check that the voltage of the electrical outlet cor-
responds to that which is indicated on the label
on the appliance. Before using the appliance for
the first time, carefully wash and dry the juicing
cones, the filter and the juice collecting container.
HOW TO USE
• Position the juice collector (G) onto the motor
(I) (Fig. 1) and turn it clockwise until it clicks
into place (Fig. 2).
• Attach the lower sieve (E) to the upper sieve
(D) (Fig. 3), making sure to insert the adju-
sting slider (F) into the corresponding slot on
the handle of the upper filter (D).
• Put the filter into the carafe and then the juicing
cone in a way that the teeth on the cone line up
with the grooves in the filter and make sure that
the filter tightly grips the juice collecting container
(Fig. 4).
• Insert the plug into the electrical outlet.
• By simply placing the citrus fruit onto the cone
and pressing slightly, the appliance will begin
to operate and extract juice into the collecting
container.
• According to the type of fruit to be juiced,
either the smaller or larger cone can be used.
The larger cone is suitable for oranges, the
smaller one for lemons. To use the larger
cone, simply place it on top of the smaller one
(fig.5).
• The motor is equipped to rotate in either
direction to obtain optimal juicing effect;
press the fruit intermittently and the motor will
invert its rotational direction.
• The quantity of pulp in the juice can be regu-
lated by adjusting the filter regulator (F) to
reduce or enlarge the holes in the filter (see
fig. 6).
To reduce the quantity of pulp, move the
regulator (F) as far as it will go to the left. To
increase the pulp, move the regulator (F) in
the opposite direction.
Important: Do not operate the Citrus Juicer con-
tinuously for more than 1 minute.
If a large quantity of juice needs to be extracted,
the juicer should operate 15 seconds and pause
15 seconds. The total running time shall not
exceed 5 minutes.
CLEANING- MAINTENANCE- SUGGESTIONS
• All cleaning and maintenance procedures
should be done when the appliance is
unplugged from the electrical outlet.
• Remove the filter by lifting it off. Detach the
cone from the filter.
• Proceed to eliminate the bits of pulp and fruit
remaining and clean the various components.
• In order to avoid having the remainders dry
on the appliance and be therefore difficult to
remove, disassemble the appliance and
clean the components immediately following
use.
• Wash the juice collecting container, filter, jui-
cing cones and the lid in lukewarm water
with mild detergent. The components should
not be washed in the dishwasher.
• The motor and its components should be
cleaned only with a damp cloth.
5