Maytronics DIY Manual De Instrucciones página 3

DIY Analyzer
Operating Instructions
1. Set up
Place the Analyzer on a clean and dry surface. Connect the Analyzer to your PC by plugging in the
communication cable between the Analyzer and your computer's USB port as shown below:
Connection Connection
to PC to Analyzer
Plug in the mains power cord to a power supply. We recommend the new Diagnostic 29V digital switch
mode power supply:
Digital switch mode Digital switch mode
power supply power supply
Note: For the Analyzer to work, it must be connected to a power supply.
Plug the cable into the
back of the Analyzer
Connect the power cord Connect the power cord
to the power supply to the power supply
Plug the cable into the
PC USB port