Gewiss Chorus GW 10 741 Manual De Usuario página 21

TEMPERATURE PROBE
The device has a built-in temperature probe. The measured temperature value is sent to the
KNX bus every 15 minutes and whenever there is a variation of at least 0.2°C.0,2°C
Make the customisations without the finish plate. Use Easy controller to configure all the functions
of the push-button panel, then subsequently disable the light signallings relating to unused
channels, according to the type of plate (2 or 4 symbols) used.
INDICATOR LIGHT
Each channel of the push-button panel module has two indicator LEDs.
The default setting provides night-time localisation (amber LED) and load status indication (blue LED). This
default setting can be changed as follows.
Change mode input
• touch channels 1 and 6 simultaneously for at least 3 seconds and 6
• wait until you hear a short beep: the LEDS activate based on the colour configuration that is active
at that particular moment
• for each channel cyclically change the colour of the LED corresponding to the status indication and night-
time localisation (colour and activation) by touching consecutively on the channel. Each combination
corresponds to the touch light effect shown in the table.
LED CHANNELS 1..6
Fixed blue
Flashing blue
(0.5s ON, 0.5s OFF)
Flashing amber
(0.5s ON, 0.5s OFF)
Fixed amber
Flashing blue/amber
alternately
Blue/amber fixed
(*) choose this mode to disable the light signallings regarding unused channels, when the push-button
panel is completed with a 2- or 4-symbol plate.
Change mode output
• to save the new settings: touch channels 1 and 6 simultaneously for at least 3 seconds and 6
• wait until you hear a short beep or
• to exit without saving: wait 10 seconds.
Blinking and indications stop and any previous indications are restored.
GENERAL DESCRIPTION
Customisations
STATUS
SIGNALLING
Blue
Blue
Amber
Amber
None
None
21
NIGHT-TIME LED COLOR
LOCALISATION TOUCH EFFECT
Amber Current LED colour
None
Blue
None
Amber
Blue Current LED colour
Blue
None
None
None
*
E
N
G
L
I
S
H