Chauvet DJ HURRICANE HAZE 3D Guía De Referencia Rápida página 4

Hurricane™ Haze 3D QRG EN
AC Power
This product has a fixed voltage power supply and it can work with an input
voltage of either 120 VAC, 60 Hz or 230 VAC, 50 Hz, depending on the
specific model.
Fuse 1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
Replacement
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
FCQ (Fog Cleaner Quart) was specifically developed by CHAUVET® to
clean your Hurricane™ Haze 3D. Make sure you use FCQ regularly to
increase the life of your product.
Mounting
Before mounting this product, read the Safety Notes.
Mounting Clamp
(works with CLP-15 or
CLP-15N clamp from
CHAUVET®)
Mounting
Safety Cable
Bracket
(works with CH-05
safety cable from
CHAUVET®)
Bracket
Haze
Adjustment
Output
Knob (x2)
Product
Mounting
Diagram
Rubber Feet
for floor mounting
While operating the Hurricane™ Haze 3D, make sure there is adequate
haze fluid in the machine to prevent pump and heater damage. When the
haze fluid tank is empty, as a safety feature, the machine will shut off.
Simply add more haze fluid to continue using the Hurricane™ Haze 3D.
4