BK Precision 601 Manual De Instrucciones página 6

Operation
The first field indicates the battery terminal voltage when battery
was loaded during the test; the second field shows the balance
capacity in percentage. IR indicates the internal resistance in milli
ohms.
After the test, follows a cooling period of approximately 15 seconds.
If user tries to perform a test during this period, the following
message is displayed.
TO BEGIN NEXT
SESSION, WAIT....
In case the open circuit voltage of BUT exceeds 14.8V, the following
screen will be continuously flashed & you will not be able to enter
the test mode.
X HIGH VOLTAGE X
REMOTE BATTERY
Once the test period elapses the following screen will be displayed.
OPEN CKT: 12.53V
SELECT AH: 028
To start a new test, press SELECT AH key & in order to repeat the
same test, press TEST REPEAT key.
To prevent unnecessary discharge of BUT, BATTERYANALYSER
will switch off automatically after 5 minutes of non-operational
period.
CAUTION
1) Do not connect Model 601 to a voltage source more than 20V.
2) Do not connect model 602 to a voltage source that is more than
50V.
3) Do not connect the unit to a battery connected in circuit.
6