Electrolux EWC 1050 Manual De Instrucciones página 8

8 electrolux
Select the required programme by
means of the programme selector dial
(9)
Turn the programme selector dial to the re-
quired programme. The selector can be
turned either clockwise or anticlockwise.
The green light of button 6 starts to flash
On programme progress display the pilot
lights corresponding to all phases compos-
ing the selected programme are lit.
On position the programme is reset and
the machine is switched OFF.
At the end of the programme the selec-
tor dial must be turned to position
switch the machine off.
Important! If you turn the programme
selector dial to another programme when the
machine is working, the lights in the
programme progress display will start to
flash to indicate a wrong selection. The
machine will not perform the new selected
programme.
Select the spin speed, Rinse Hold or No
spin option (8)
Select the spin speed, Rinse Hold option or
No Spin option by turning the spin speed se-
lector.
• The position 1300 (or 1000) is equivalent
to 900 rpm for the synthetic and wool pro-
grammes and 700 rpm for the delicate
wash programme.
• The position 500 is equivalent to 500 rpm
for the synthetic and wool programmes
and 450 rpm for the delicate wash pro-
gramme.
Rinse hold
By selecting this option the water of the last
rinse is not emptied out to prevent the fabrics
from creasing. When the programme has fin-
ished, the lights "End" and "Door locked" are
lit to indicate that the water must be emptied
out (See: " At the end of the programme").
No spin
By selecting this option all the spinning pha-
ses are excluded. To be used for extremely
delicate material. The machine will add some
additional rinses to the cotton and synthetic
programmes.
For the maximum spin speed allowed by
each programme, refer to the chapter
Washing programmes .
Select the Delay Start by pressing
button 2
Before you start the programme, if you wish
to delay the start, press the button 2 repeat-
edly, to select the desired delay. The corre-
sponding pilot light will light up.
to
You must select this option after you have set
the programme and before you press button
6 .
You can cancel or modify the delay time at
any moment, before you press button 6 .
Cancelling the delayed start after having
pressed button 6 :
1. Set the washing machine to PAUSE by
pressing button 6 .
2. Press the button 2 once, the light relevant
to the selected delay goes off.
3. Press button 6 again to start the pro-
gramme.
Important! The selected delay can be
changed only after selecting the washing
programme again.
The door will be locked throughout the delay
time (door locked light lit).
The Delay Start can not be selected with
DRAIN or SPIN programme.