Getting Good Remote Control Range And Response - Bose LIFESTYLE 35 Serie Guía De Uso

English Español
* See Remote Version in "Remote control options" on page 32.

Getting good remote control range and response

The cord that connects the power supply to the VS-2 and the VS-2 to the media center
contains an antenna for your RF remote. For good range, it is VERY important that you extend
this cord to its full length and keep it away from other system cables. Placing the power
supply on the floor, well below the media center, puts the cord in a vertical orientation, which
is optimum.
Note: When using a plasma screen TV, keeping the media center power supply as far from the
TV as is practical improves remote range.
If your system does not respond when you press a button on the remote, it could be time to
change the batteries. For information on the type of batteries to use and how to change them,
refer to "Replacing the remote control batteries" on page 41.
In some buildings, there may be "dead spots" where remote control signals are not effective.
If this happens, move the remote a foot or two and try again. If this does not help, move the
media center a few feet to see if a new location provides better response.
If the batteries are not dead and your efforts to avoid dead spots are in vain, you may need an
antenna extender. To contact Bose for more information, or to order the extender, refer to the
contact list included with the system.
Français
If your remote has this button* above the Settings button, the four buttons
on the bottom of your remote perform the following functions:
In VCR source (or AUX, if a recorder-type device is connected to that input),
activates the record function. Not available on remotes set to control Teletext.
In Cable source, makes a selection from the A list.
In Cable source, makes a selection from the B list.
In Cable source, makes a selection from the C list.
If your remote has this button* above the Settings button, the four colored
buttons on the bottom of your remote perform the following functions:
In Teletext mode, selects the content labeled red.
In Teletext mode, selects the screen content labeled green.
In Teletext mode, selects the screen content labeled yellow.
In Teletext mode, selects the screen content labeled blue.
S C
YSTEM ONTROLS
11