Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WatchIN ID: DIP Switches 1 - 5
ID
1
2
01
OFF OFF OFF OFF OFF
02
ON
OFF OFF OFF OFF
03
OFF ON
OFF OFF OFF
04
ON
ON
OFF OFF OFF
05
OFF OFF ON
06
ON
OFF ON
07
OFF ON
ON
08
ON
ON
ON
09
OFF OFF OFF ON
10
ON
OFF OFF ON
11
OFF ON
OFF ON
12
ON
ON
OFF ON
13
OFF OFF ON
14
ON
OFF ON
15
OFF ON
ON
16
ON
ON
ON
ProSYS Programming (from ProSYS software version 7.xx and above)
The following section describes the additional software programming options, added to the
ProSYS software, that concern the settings of the WatcIN DT as a BUS detector. Up to 32 BUS
detectors can be added to the system (16 in ProSYS 16) and each of them comes at the expense
of a zone in the system.
It is recommend reading and fully understanding the ProSYS Installation and User Manuals,
before programming the WatchIN.
Notes:
The WatchIN is compatible with the ProSYS software Version 7.xx and above.
The WatchIN can be programmed via the U/D Software supporting ProSYS software Version 7.xx and above.
For maximum operation stability, it is best NOT to exceed a total of 300 meters (1000 feet) of wiring when
connecting the WatchIN to the BUS.
Adding / Deleting the WatchIN DT
The WatchIN is part of an accessory category, BUS zones. Therefore, Adding/Deleting the
WatchIN is identical to any other accessory with the following exception:
Each BUS Zone Detector should be assigned to a Regular Zone.
Any BUS detector can be assigned to a physical wired zone or to a virtual zone.
Physical zone: Any zone on the ProSYS PCB (zones 1-8) or on a wired zone expander
(ZE08, ZE16).
Virtual zone: Any zone on a BUS zone expander defined as BZ08 or BZ16.
Notes:
Virtual BUS zones are cost effective. They enable to expand your system zones without adding physical zone
expanders.
The virtual BUS zone expander can be used only for BUS zone detectors.
To add a BUS zone expander select type BZ08 or BZ16 when adding a zone expander (Quick key [7][1][2]).
1. To Add / Delete the WatchIN DT
1. From the installer menu enter the Add/Delete menu: Quick Key [7][1][9][5] for BUS Zones
detectors.
2. Use the
ID number for which you want to assign (or delete) a detector.
18
3
4
5
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
/
or
WatchIN Installation Manual
ID
1
2
17
OFF OFF OFF OFF ON
18
ON
OFF OFF OFF ON
19
OFF ON
20
ON
ON
21
OFF OFF ON
22
ON
OFF ON
23
OFF ON
24
ON
ON
25
OFF OFF OFF ON
26
ON
OFF OFF ON
27
OFF ON
28
ON
ON
29
OFF OFF ON
30
ON
OFF ON
31
OFF ON
32
ON
ON
/
keys to position the cursor over the BUS Zone
3
4
5
OFF OFF ON
OFF OFF ON
OFF ON
OFF ON
ON
OFF ON
ON
OFF ON
ON
ON
OFF ON
ON
OFF ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
Publicidad
Capítulos
Tabla de contenido
