Optional Swivel Installation (Not Supplied) - Upgrading everyday security EL-2800 Instrucciones De Instalación

EN
Note:
DIP Switch 1 should be in ON position to enable LED indications (regardless during the first 20 minutes after
power up).

Optional Swivel Installation (Not Supplied)

Please follow the instructions below for mounting the detector with the Swivel:
1. Open the Wireless PIR Outdoor Detector front cover (Unlock C1, Figure 1).
2. Release internal base (Unlock I1, Figure 2).
3. Remove back tamper from the internal base (see the "Changing Back Tamper Position"
paragraph on page Error! Bookmark not defined.) and connect it to S5 (Figure 8, Detail A)
on the Standard Swivel.
4. Select the mounting installation as follows:
Note:
•
The swivel mount has not been evaluated by UL
•
Ensure that you see the engraved UP mark on the upper front face of the swivel.
Wall Mounting
Insert back tamper wires through the Swivel Wires Passage (Figure 8, Detail B).
1.
Secure swivel to the wall through holes S1, S3, S6 and S8.
2.
Detail A
Standard Swivel
S1
S8
Connect the external base to the swivel using the dedicated snaps (Figure 9).
3.
S2
S4
S5
S6
Tamper
(see Detail C)
Detail B
W1
S1
Figure 8
10
Snaps
S2
S3
Detail C