Adjusting The Suction Power; Dust Extraction; Adjusting The Surface Control Light - Festool PLANEX LHS 2 225 EQI Manual De Instrucciones Original

8.5

Adjusting the suction power

The long-reach sander can adhere itself to the
sanding surface, which helps you work more ef­
fortlessly.
► Set a low suction power.
► First, switch on the power tool and then
place it on the sanding surface.
► Slowly increase the suction power until a
noticeable application pressure is reached.
The suction regulator [1-15] can be
used to adjust the suction power
according to the sanding surface.
Ceiling
Maximum suction power
Wall
Minimum suction power
If the suction power is set too high, this
can lead to the power tool being overload­
ed, poor guidance or poor surface quality.
8.6

Dust extraction

WARNING
Health hazard posed by dust
► Always work with an extractor.
► Comply with national regulations.
► Wear a dust mask.
The power tool does not have its own extractor
unit. A Festool mobile dust extractor with an
extractor hose diameter of 1-7/16" (36 mm) or
1-1/16" (27 mm) should therefore be connected
to the extractor connector [1-11] (1-7/16"
(36 mm) recommended due to the reduced risk
of clogging and higher suction power).
Recommendation: Use an antistatic extractor
hose. This helps reduce the electric charge.
Always use the Festool CTL/M 36 E AC-
LHS or PLANEX mobile dust extractor for
the long-reach sander, as they are per­
fectly designed for large quantities of dust
and have a dedusting system.
8.7

Adjusting the surface control light

The surface control light button [1-4] can be
used to switch the surface control light on and
off even when the power tool is switched off.
The surface control light switches off after one
hour when the power tool is switched off.
Controlling the surface control light via the
Festool Work app
If the power tool is connected to the
Festool Work app via Bluetooth
tion 8.8), the surface control light can be con­
figured.
English
® (see Sec­
15