Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions
6. Screw the connector cover on the sensor cable.
Step 7
8. Optional single temperature installation without
mixing valve:
Connect supply hose to tee shaped fitting with
a ½" nipple (not included). Do NOT remove
the tee shaped filter from the control module.
Step 9
10. Connect supply hoses to the mixing valve and
supply stop valve. Plug in transformer if used.
Check for leaks.
OPERATION
1.
Place hands under spout. Water will flow for as long as the user's hands remain
within sensor range.
2.
Clean filter every month.
3.
Keep electronic eye cover clean.
4.
Red flashing in the electronic eye indicates low batteries. (Replacement batteries:
Alkaline AA.)
5.
Solid red light in the electronic eye and no water flow indicates batteries are dead.
6.
When used in conjunction with the optional AC adapter, the faucet will automatically
switch to AC power and conserve its battery power.
Fresh alkaline batteries should last 400,000 on/off cycles.
7. Connect the mixing valve to the tee-shaped
fitting with filter.
9. Mount the control module to the wall
with screws and wall anchors (not included).
3
Step 6
Optional: Step 8
Step 10
Publicidad
Tabla de contenido
