AKG WMS40 Modo De Empleo página 15

6. If your voice sounds distorted on the
loudspeakers turn the input gain con-
trol (3) down CCW to the point that
you will hear no more distortion.
If your voice sounds too quiet on the
loudspeakers, turn the input gain
control (3) up CW. If the loudspeakers
start howling due to acoustic feed-
back, immediately turn the input gain
control (3) back down to the point
that the howling will stop.
4.3 Detaching the Microphone
Refer to fig. 5):
If feedback occurs even at low volume
levels, you can detach the microphone
from the transmitter and position it
closer to the talker's mouth to reduce
the risk of acoustic feedback.
1. Unlock and remove the cable com-
partment lid (1).
2. Place your fingernail against the
2a.
1.
2b.
4.
Fig. 5: Detaching the microphone.
microphone body and pull the micro-
phone (3) out of the microphone
compartment.
3. Pull the microphone (3) away from
the transmitter.
4. Replace the cable compartment lid (1)
on the cable compartment and press
3.
the lid (1) down to make it snap shut.
5. Put the transmitter in the shirt pocket
or outside breast pocket or hang it
around the talker's neck with the
necklace cord.
6. Clamp the microphone (3) on the sel-
vage or the collar as close as
possible to the talker's mouth.
7. Turn the microphone (3) to aim it at
the talker's mouth.
4.4 Mounting the Microphone on
the Transmitter
Refer to fig. 6:
5./6./7.
1. Unlock and remove the cable com-
partment lid (1).
15