Publicidad
Assemble Chicco Infant Seat Attachment
Armar el accesorio del asiento de seguridad infantil de Chicco
36
"CLICK!"
"CLIC"
"CLICK!"
"CLIC"
Side Hubs
Cubos laterales
36. Lay out the Side Hubs with the short tube sides to the right of the Hubs.
Then place an end on each side of the Side Hub. Insert the Side Hub tubes into
both Ends until the snap buttons click into place.
36. Coloque los cubos laterales en los tubos laterales cortos a la derecha de
los cubos. Luego, coloque un extremo en cada lado del cubo lateral. Inserte los
tubos del cubo lateral en ambos extremos hasta que los botones de broche
hagan clic.
46
Ends
Extremos
"CLICK!"
"CLIC"
Short
Tubo
lateral
Tube
Side
corto
"CLICK!"
"CLIC"
To Attach Chicco Infant Seat Attachment
Instalar el accesorio del asiento de seguridad infantil de Chicco
Short Tube Side
37
Tubo lateral corto
"CLICK!"
"CLIC"
Direction of Travel
37. Remove the Seat from the Stroller
Frame, as shown in Step 35. Line up
the Hubs on both sides of the Chicco®
Infant Seat Attachment to the Hub
slots on the Stroller frame as shown.
Make sure that the short tubes of the
Infant Seat Attachment are pointing
towards FRONT of the stroller frame
in Direction of Travel. Pull up on the
Infant Seat Attachment to make sure
it is securely attached to the Stroller
Frame.
Note: The infant car seat can be
attached in a Forward Facing
position and a Parent Facing
position, as shown.
Forward Facing
Parent Facing
Position
Position
47
Publicidad
