Unpacking; Assembly; Wheel Installation - Shop-Air SAIR Serie Manual De Usuario

GROUNDING INSTRUCTIONS (CONT'D.)
This appliance is for use on a nominal 120-volt circuit, and has a grounded plug that looks like the plug
illustrated in sketch A. A temporary adaptor that looks like the adaptor illustrated in sketches B and C may
be used to connect this plug to a 2-pole receptacle as shown in sketch B if a properly grounded outlet is
not available. The temporary adaptor should be used only until a properly grounded outlet (sketch A) can
be installed by a qualified electrician. The green colored rigid ear, lug or the like extending from the adaptor
must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the
adaptor is used, it must be held in place by a metal screw.
IN CANADA, ThE USE OF A TEMPORARy ADAPTOR IS NOT PERMITTED by ThE CANADIAN ELECTRICAL
CODE. Make sure that the appliance is connected to an outlet having the same configuration as the plug. No
adaptor should be used with this appliance.
SKETCH A
Unpack air circulator from carton. Lift unit using the top carry handle.

WHEEL INSTALLATION

you will find two wheels, two spacers, two bolts, two washers and two lock nuts with the unit. Assemble as
follows:
1. Place one wheel on a bolt making sure flat side of wheel hub is facing the bolt head.
2. Slide one spacer onto bolt and slide it down to the wheel.
3. Locate the wheel bracket installed on the bottom of the unit. The bracket is on the end
of the unit containing the switch and has one hole in each side.
4. Insert the bolt, containing the wheel and spacer, into one of the holes on the side of the
wheel bracket.
5. Place the washer over the end of the bolt and secure with a lock nut.
6. Repeat these steps to install the wheel on the other side of the wheel bracket.
PAGE 4
GROUNDING METHODS
SKETCH B

UNPACKING

ASSEMBLY

SKETCH C