Alarm Operation - Timex T256 Manual De Instrucciones

The sleep timer will shut the radio off automatically so you can fall asleep to the radio. Maximum sleep time is 59 minutes.
Press the 3 Sleep Button.
1.
2. Select the station and adjust the volume to the desired level. Remember that the station and volume selected will also
be heard in the morning if you select wake to radio (see Alarm Operation)..
To adjust the amount of sleep time, press and hold the 3 Sleep Button. The display will begin counting down from "59". Release
3.
the 3 Sleep Button when the display reaches your desired sleep time. When the display counts down to "00" the radio shuts
off automatically.
To stop the radio before the timer reaches "00" press the 4 Snooze Button.
4.
Set alarm time as indicated in Setting Alarm Time.
1.
Push the 1 Alarm On/Off Button to "down position". A small dot will appear in the lower left corner of the display
2.
indicating the alarm function is on. The alarm is now set to turn on automatically at the time selected.
Note: The alarm will play for approximately 2 hours and turn off automatically. This cycle will repeat every 24 hours
unless the controls are changed.
For wake to radio, set the N Wake-To Switch to "Radio". Please select the station and volume you want to hear when
3.
you wake up. For wake to bell sounds, set the N Wake-To Switch to buzzer. The buzzer alarm is equipped with a
"Gentle Wake" alarm system. When the alarm goes on it will begin at a low level and gradually become louder until it
reaches maximum volume or unit you stop the alarm.
After the alarm goes off, press the 7 Alarm Set/Reset Button to turn off the alarm. The alarm will come on again
4.
the next day at the same time.
To stop the alarm from coming on the following day, set the 1 Alarm On/Off Button to "up" position. The dot on the
5.
display will disappear.
Press the 4 Snooze Button after the alarm sounds. The alarm will go off and will come on again in approximately 9
1.
minutes. You may repeat this cycle several times during the 2 hours alarm cycle.
If the L Snooze Flash Switch is set to "ON" the snooze bar will flash when alarm comes on. Otherwise, the snooze
1.
bar is always lit.
Sleep to Radio

Alarm Operation

Consumer Repair Department
Snooze Operation
Flashing Snooze Bar
5